Paint, layer, give it a face
Toddler Lion Craft: A Paper Plate with a Shaggy Mane
A yellow plate, a slightly chaotic paper mane, and a face your toddler can make their own. The strips go behind the rim, so the lion keeps its shaggy outline.

The mane is the part your toddler will take personally. They might arrange every orange strip in a tidy circle, or give the lion an alarming haircut on one side. Both work. This paper-plate lion uses a painted face and broad paper strips attached behind the rim, so the finished animal has a proper shaggy outline without asking your child to cut twenty matching pieces.
You do the cutting, your toddler handles the paint and big glue presses, and the face waits until the plate is dry. That last bit saves a lot of marker frustration. On wet paint, a marker can skid, stop working, or draw a nose that looks like it has just sneezed. We are making a lion, not diagnosing its bad morning.
Set aside one plate for this project and keep any spare orange paper. The offcuts can become a tail or a pretend crown later. If your child would rather paint a whole scene today, the easy toddler painting activities collection has other setups; this page is for making one sturdy, recognizable animal.
Paper-Plate Lion Craft for Toddlers
Makes one lion with a painted face and layered paper mane.
Materials
- 1 uncoated paper plate, about 9 inches across
- 1–2 teaspoons yellow washable tempera paint
- 1 sheet orange construction paper, about 9 by 12 inches
- 18–22 orange strips, roughly 1 inch wide and 3 inches long, cut from that sheet
- 2 large semicircle paper ears, roughly 2 inches wide
- 1–2 teaspoons white washable craft glue
Tools
- Broad paintbrush
- Adult scissors
- Black washable marker
- Washable mat and scrap paper for glue

Step-by-step method
- Cut the paper pieces. An adult cuts about twenty broad strips and two large ears from orange paper. The lengths can vary a little. Make the strips wide enough for your toddler to hold without crumpling them into tiny ropes.
- Paint the plate face. Place the plate front-side up and offer a small amount of yellow paint. Your toddler can cover the center and rim with broad strokes. Spread thick puddles with the brush so the plate can dry without a soggy middle.
- Let the paint dry. Move the plate to a safe flat spot until the surface feels dry. You can cut another paper strip or put the brushes away during the pause. Do not press on the wet center to check every thirty seconds; the paint is not persuaded by attention.
- Turn it over. Place the dry plate face down on clean scrap paper. Arrange a few strips loosely behind the rim before gluing. Leave about an inch of each strip resting on the back of the plate, with the remaining length sticking out beyond the edge.
- Glue a short section. Brush a thin patch of glue along four or five inches of the back rim. Let your toddler press three or four strips into it, spreading them outward like sun rays. Hold each broad end for a moment before moving to the next section.
- Work around the circle. Rotate the plate and repeat the short glue patches. Overlap strips slightly at their inner ends so the mane looks full. Keep the outer ends loose; they give the lion its shaggy outline. Add a second strip only where a gap bothers your child.
- Add the ears. Glue the two large semicircles behind the upper rim between mane strips. Keep enough of each ear on the plate for a firm attachment. Let the whole back dry flat before turning the lion face up.
- Draw the face. An adult or child draws two big eyes, a triangle nose, a short line down from the nose and two curved mouth lines. A few broad whisker marks are optional. If your toddler wants purple eyebrows, this lion can carry them with dignity.
How to make the mane look full without a glue flood
The plate rim gives you a useful boundary. Keep the inner inch of the paper strip on the back, and aim the rest outward. If all strips point sideways, you get a paper wreath rather than a mane. Turn the plate as you work so your toddler can always press the nearest section instead of reaching across fresh glue.
Do not glue the entire rim at once. The last section may dry before you get there, and a toddler can smear the first section with one wandering elbow. Small patches keep the job manageable. If your child enjoys placing five strips and stops, leave the plate face down and come back later.
The same press-and-attach habit appears in the paper-plate jellyfish, where tissue strips hang from a straight edge instead of pointing around a circle. You can set aside the paper-plate supplies for that ocean project without making the two crafts look alike.

Troubleshooting
Paper strips keep sliding
There is probably too much glue. Lift one strip, spread the glue into a thinner film and press it back down. Leave the plate face down while that section sets.
The mane has bald patches
Add one broad strip into each gap with about an inch overlapping the plate back. It is easier to repair a few spaces than to peel off the whole mane.
The painted plate curls
The paint layer was very wet. Let the plate dry fully before assembling. Next time offer a teaspoon of paint at a time and use the brush to spread pools over a wider area.
The marker will not draw
The paint may still be damp or too glossy. Wait longer, then test the marker on scrap paper. A dark crayon can draw a face on the dry plate if the marker continues to skip.
A strip tears during play
Trim off the torn piece at the back and glue in a new broad strip. Avoid a small patch at the outer tip; it usually becomes the next thing your child pulls off.
Three ways to change it
Two-tone mane
Use broad yellow and orange strips in alternating sections. Let your child choose the order instead of demanding a pattern. Keep the face yellow so its features remain easy to see.
Torn-paper mane
Offer broad paper rectangles your toddler can tear into chunky strips. Keep the attachment ends wide, even if the outer ends are wonderfully ragged. The torn texture suits a lion better than it suits your kitchen paperwork.
Quiet version with crayons
Color the plate with a yellow crayon instead of paint, then make the same mane. You can move straight to the glue stage because the face does not need to dry. This is handy if the paintbrushes are all still in the sink.
Finishing without flattening the mane
Let the glue dry with the face down and the paper ends spread around the plate. Once the strips stay put when lightly touched, turn the lion over. If you want a wall display, an adult can tape a small loop to the back; place it where your child can look without tugging the paper mane.
Keep the lion flat for storage, or stand it gently against a shelf. Do not stack a heavy book over the strips unless you want a lion with very sleek hair. A folder wide enough for the whole mane works for keeping it after the paint-and-glue stage is over.
For a second animal from the leftover plates, the tissue-paper fish craft uses one plate wedge for both its mouth and tail. The paintbrush can stay put away for that one. If you have spare tissue paper after making the fish, the contact-paper suncatcher uses color pieces without a glued plate base.
The low-mess toddler crafts roundup is useful when you want the next project to fit a shorter window. For this lion, it is fine to split painting and assembly over two days. The craft does not expire because snack happened halfway through.
Questions parents ask
What age can make a paper-plate lion?
A toddler can paint the plate and press broad paper strips while an adult cuts and manages the glue. Around age three, many children also want to draw the face. Match the amount of help to your child and stay alongside them.
Can I make a lion without paint?
Yes. Color the face with yellow crayon or use an already colored paper plate. A plain uncoated plate is still the easiest surface for drawing and attaching paper.
How many strips do I need for the mane?
About eighteen to twenty-two broad strips work around a nine-inch plate. Start with fewer and fill the gaps after seeing the first layer. Strips roughly an inch wide are easier to handle than narrow fringe.
Should the mane go on the front or back?
Attach it to the back so the strip ends stay hidden and the face has a clean outline. Leave about an inch of each strip overlapping the plate. Dry the glue before flipping it over.
Can I use a glue stick instead of liquid glue?
A glue stick may work for light paper on a flat plate surface, but the curved rim can be awkward. Press firmly and test a strip before assembling the whole mane. A thin layer of washable craft glue gives you more contact across the rim.









Leave a Reply